M25

M25 Motors / MOT preparation

MOT preparation checklist for London drivers: what to check before the test

An MOT checks whether a vehicle meets minimum roadworthiness and environmental standards on the day of the test. A few simple checks can help you spot obvious issues beforehand, but they cannot guarantee a pass or replace the official test. Use this guide to prepare your car, understand the limits of a pre-MOT check and decide when to arrange a repair inspection.

9 min readBy M25 Motors
A car ready for inspection at a garage

1. Check the due date and past advisories

Use the GOV.UK MOT service to check the vehicle’s current MOT status, expiry date and recorded test history. Previous results can help you spot repeat advisories, such as tyre wear, suspension play or a recurring lamp issue. An advisory is not the same as a failure, but it is a useful prompt to check whether the condition has changed since the last test.

For most cars, the first MOT is due when the vehicle is three years old, then every year. There are exceptions, so confirm the rules for your vehicle on GOV.UK rather than relying on the registration date from memory. Book early enough to leave time to address any problems that are found.

A valid MOT does not remove the driver’s responsibility to keep the vehicle roadworthy between tests.

2. Inspect tyres and wheels

Check every road tyre for obvious cuts, bulges, exposed cords or other damage. Look across the tread rather than only at the outside edge, because uneven wear can point to a pressure, alignment, braking or suspension problem. Confirm that tyres are correctly inflated for the vehicle using the pressure information in the handbook or on the car.

For cars and light vans, the legal minimum tread depth is 1.6 mm across the central three-quarters of the tyre and around its full circumference. That is a legal limit, not a recommendation to wait until the last moment: have a tyre inspected if its condition concerns you, or if the tread is close to the limit.

3. Check lights, indicators and number plates

With the vehicle safely parked, check that the headlights, sidelights, indicators, hazard lights, brake lights, rear lights and number plate lamps work. Ask another person to confirm the brake lights if necessary. Look for cracked or badly damaged lamp covers and make sure the number plates are clean, legible and securely fitted.

If a bulb is replaced, use the type and fitting specified for the car. Poorly fitted or unsuitable lamps can cause a problem even when they illuminate. If a warning message remains after a repair, check the handbook or have the system assessed rather than assuming the warning will clear by itself.

4. Make sure the driver has a clear view

Clean the windscreen, mirrors and windows. Check the driver’s view for chips or cracks, and make sure the wipers sweep the screen effectively without leaving large uncleared areas. Test the washers and top up the correct washer fluid if needed. A wiper blade that is split, loose or leaving a streak may need attention before the test.

Also check that mirrors are present, secure and usable, and remove anything from the dashboard or windscreen that blocks your view. If a chip is in the driver’s field of vision or is growing, ask a glass specialist whether it needs repair or replacement.

5. Take brake, steering and suspension symptoms seriously

Do not try to diagnose brake performance with a hard stop on a public road. Instead, note whether the car pulls to one side, vibrates under braking, makes a grinding sound or has a pedal that suddenly feels soft, spongy or unusually hard. These symptoms need an inspection; if braking feels unsafe, stop in a safe place and arrange professional assistance rather than continuing to the test centre.

Pay attention to steering that feels loose, heavy or newly off-centre, and to unusual knocking or excessive bouncing over bumps. Such changes are worth reporting before the test. The MOT checks brakes, steering, suspension and related warning lamps according to the current DVSA inspection manual.

6. Look at warning lamps, horn and seat belts

Read the handbook for any dashboard warning that remains illuminated after the engine starts. The MOT inspection includes specific warning lamps and vehicle systems, and the rules vary by item and vehicle. Do not cover, remove or reset a warning to hide it: the underlying fault may still affect safety or the test result.

Check that the horn works, seat belts latch and retract properly, and seats are secure. These simple checks are easy to overlook when attention is focused on the engine or tyres, but they are among the items covered by the official inspection process.

7. Know what the MOT does not test

An MOT is not a full mechanical health check. GOV.UK states that the test does not cover the condition of the engine, clutch or gearbox. A car can pass and still need maintenance or repair in those areas, and a pre-MOT inspection cannot promise an official pass. If you have a separate noise, leak, clutch slip or engine warning, book an assessment for that symptom rather than treating the MOT as a diagnosis.

If the test identifies a defect, ask the tester to explain the result and the next steps. Distinguish a recorded advisory from a defect that has caused a failure, and use the official GOV.UK guidance if you are unsure whether the car can be driven. Rules depend on the result and the vehicle’s condition.

8. When a pre-MOT garage check helps

A pre-MOT check can be useful when the vehicle has visible wear, old advisories, a warning lamp or symptoms that might affect roadworthiness. Tell the garage about the test date, the previous MOT history and any changes you have noticed. Ask which items are being checked and request approval before any repair work is carried out.

M25 Motors provides MOT preparation and repair enquiries for London drivers. Share the registration, mileage and symptoms to discuss whether a preparation check or a specific repair inspection is the sensible next step. The official MOT result is still determined by the authorised test.

Common questions

How early can I get my car’s MOT done?

Check the MOT due date and current rules using GOV.UK. Booking ahead helps leave time for repairs if an inspection finds a problem; the exact date that preserves the existing expiry date depends on the current MOT rules.

Will a pre-MOT check guarantee a pass?

No. A pre-MOT check may identify concerns, but it is not the official test and cannot guarantee its result. The authorised MOT tester records the vehicle’s result against the current inspection requirements.

Does an MOT cover the engine and clutch?

No. GOV.UK says the MOT test does not cover the condition of the engine, clutch or gearbox. Arrange separate maintenance or a fault diagnosis if you have concerns in those areas.

Official references

Use these primary sources for current rules and vehicle-specific guidance.

General information only. It is not a diagnosis or a substitute for your vehicle handbook, official guidance or an in-person inspection. If the vehicle may be unsafe, stop somewhere safe and seek professional assistance.